Weigh station sensor replacement will mean delays on Teton Pass

JACKSON, Wyo. – Mark these two dates down on your calendar if you do the commute thing to or from Teton Valley.

On June 23-24 the Wyoming Department of Transportation will be changing out roadway sensors for the weigh-in-motion on WYO 22. The work will take place from 8:30 a.m. to 4 p.m. on each day. The sensors are located at roughly milepost 17.

Crews will have the road reduced to one-lane, with alternating traffic. Motorists will be flagged through the work zone in alternating directions. WYDOT is anticipating delays of up to 15 minutes, but those times could increase with traffic congestion.

You May Also Like
Community
Old Pass Road improvement project to begin July 10th
News
Wilson Bridge work will cause delays this week
News
Flat Creek Bridge construction going to take a little longer
Politics
WYDOT to close 10 rest areas as a cost-saving measure
Town & County
Tribal Trails connector moves ahead despite opposition
Community
Swinging Bridge to close for 2 days